Hi,
I have had this system working fine for about 3 years with a Worcester 30CDi Classic boiler but over the past 4 or 5 months my DT92E thermostat LCD display blanks off sometimes when I go to adjust settings :/
So, I bought another DT92E received it today and am trying to pair it to the programmer. The ST9420C programmer is in binding mode but refuses to SYNC with the DT92E.
Ok, I thought I'd just rebind the old unit once again. Its having none of it. I don't really want to have to shell out for another ST9420C programmer as well but is this likely to be the issue (I am leaning towards this even though it was working fine right up until I tried the pairing/binding process).
Am I missing something obvious here?
Cheers
Small update: The binding never shows completed but when I try to rebind each time the programmer shows 'bnd' indicating a device is already attached! The programmer is reset of all bindings I might add and the original and new DT92E is also cleared.
I have had this system working fine for about 3 years with a Worcester 30CDi Classic boiler but over the past 4 or 5 months my DT92E thermostat LCD display blanks off sometimes when I go to adjust settings :/
So, I bought another DT92E received it today and am trying to pair it to the programmer. The ST9420C programmer is in binding mode but refuses to SYNC with the DT92E.
Ok, I thought I'd just rebind the old unit once again. Its having none of it. I don't really want to have to shell out for another ST9420C programmer as well but is this likely to be the issue (I am leaning towards this even though it was working fine right up until I tried the pairing/binding process).
Am I missing something obvious here?
Cheers
Small update: The binding never shows completed but when I try to rebind each time the programmer shows 'bnd' indicating a device is already attached! The programmer is reset of all bindings I might add and the original and new DT92E is also cleared.
Last edited: