This is completely my fault but I’ve fitted a new internal door (it’s a solid pine, part-glazed door) but when I scribed it, I’ve set it up wrong and have taken about 4-5mm more off the sides than I should have (2.5mm more off each side).
this is an issue as the latch only just catches the plate and doesn’t hold the door shut. I know the easy answer is buy a new door but it was pricey so would rather not.
can I add a strip to the lining to make it thicker and to close the gap (then fill, sand, paint so it doesn’t really show) or are there any other ways?
Thanks.
this is an issue as the latch only just catches the plate and doesn’t hold the door shut. I know the easy answer is buy a new door but it was pricey so would rather not.
can I add a strip to the lining to make it thicker and to close the gap (then fill, sand, paint so it doesn’t really show) or are there any other ways?
Thanks.