Hi all,
I’ve got an ideal mini s24, works fine, had a new full sequence PCB last year.
As it’s getting cold, I’ve put the central heating back on. It was working fine the last few days but now, nothing.
Hot water is fine, boiler fires up and I get hot water.
When I turn the heating on with my Hive thermostat, I set a target temperature higher than what the actual is, the hive receiver lights up showing central heating is on, I can hear a little solenoid move (box on a pipe) and that’s it, boiler does nothing what so ever.
Pressure is 2 bar, temp about 40 as seen on the boilers gauge.
No error codes as it doesn’t try to do anything so is off..
Any clues?
Cheers
I’ve got an ideal mini s24, works fine, had a new full sequence PCB last year.
As it’s getting cold, I’ve put the central heating back on. It was working fine the last few days but now, nothing.
Hot water is fine, boiler fires up and I get hot water.
When I turn the heating on with my Hive thermostat, I set a target temperature higher than what the actual is, the hive receiver lights up showing central heating is on, I can hear a little solenoid move (box on a pipe) and that’s it, boiler does nothing what so ever.
Pressure is 2 bar, temp about 40 as seen on the boilers gauge.
No error codes as it doesn’t try to do anything so is off..
Any clues?
Cheers