Hi All,
I have purchased a Digistat 1 room thermostat and I cannot get it to work!
I have 2 wires coming from the wall where the old thermostat was. Both are the same colour (grey), and I am guessing it is a ‘switched live’ wire as one is live (phase tester) and the other is not.
I connected the live wire to terminal 1 (common) and the other wire to terminal 3 (call for heat) and the heating did not come on. When I turn the thermostat down to below the room heat, I can hear the ‘click’, and also when I turn it back up! I also tried other terminal combinations but still no power!
I finally had to just connect the 2 wires to get the heat going again.
Is there something I am doing wrong!
fyi, I live in Ireland!
Rgds
Joe
I have purchased a Digistat 1 room thermostat and I cannot get it to work!
I have 2 wires coming from the wall where the old thermostat was. Both are the same colour (grey), and I am guessing it is a ‘switched live’ wire as one is live (phase tester) and the other is not.
I connected the live wire to terminal 1 (common) and the other wire to terminal 3 (call for heat) and the heating did not come on. When I turn the thermostat down to below the room heat, I can hear the ‘click’, and also when I turn it back up! I also tried other terminal combinations but still no power!
I finally had to just connect the 2 wires to get the heat going again.
Is there something I am doing wrong!
fyi, I live in Ireland!
Rgds
Joe