I have a kitchen just over 4m along one side of the room, after just over 2m I have a brick pier that will need cutting around. At this point the the kitchen units set back.
The worktop before the pier is a standard 600mm, the other will be a breakfast bar cut down to 675mm. The units have been brought forward to allow for a waste pipe run behind an integrated dishwasher.
Any ideas how to join the two worktops? I've attached a picture with two pieces of OSB, that is the way the worktops will be oriented.
The worktop before the pier is a standard 600mm, the other will be a breakfast bar cut down to 675mm. The units have been brought forward to allow for a waste pipe run behind an integrated dishwasher.
Any ideas how to join the two worktops? I've attached a picture with two pieces of OSB, that is the way the worktops will be oriented.