hi
after spending almost half a day cutting a piece of worktop for a sink cut out (long story) i noticed a gap of about 6 mm between worktop and wall, probably due to uneven wall, or more than likely my cutting.
anyway whats the best way of filling that gap prior to sealing, its not the whole lenght of the worktop only about 1/3, the rest is pretty close to the wall.
i could use those self adhesive sealing strips about an inch wide, but worried it will look tacky and after a while start coming away
i have used upstands before, but regretted using the mdf one behind the sink as water got in and the laminate started to come away from mdf.
thinking of maybe using foam expanding filler, just to fil the gap level, then using nornal sealant to finish.
dont mind bodging it, wont be the first time!
i am not the greatest in DIY, more "Destroy it Yourself"
any advice appreciated
after spending almost half a day cutting a piece of worktop for a sink cut out (long story) i noticed a gap of about 6 mm between worktop and wall, probably due to uneven wall, or more than likely my cutting.
anyway whats the best way of filling that gap prior to sealing, its not the whole lenght of the worktop only about 1/3, the rest is pretty close to the wall.
i could use those self adhesive sealing strips about an inch wide, but worried it will look tacky and after a while start coming away
i have used upstands before, but regretted using the mdf one behind the sink as water got in and the laminate started to come away from mdf.
thinking of maybe using foam expanding filler, just to fil the gap level, then using nornal sealant to finish.
dont mind bodging it, wont be the first time!
i am not the greatest in DIY, more "Destroy it Yourself"
any advice appreciated