- Joined
- 26 Jan 2005
- Messages
- 266
- Reaction score
- 0
- Country
One of my kitchen worktop joints has obviously got water in it somehow, and one edge of a 90 degree joint has slightly lifted/expanded.
I should say that this is a very small area - a coupleof centimetres long and only raised by approx 2mm. But it is noticeable. I have cleared out the old colorseal and reapplied over this area, but I still get the impression it is lifting , though it may be my imagination.
Is there anything else I can do, or is it a case of what is done is done. Will it get any worse?
Not really sure why this has happened. The joint was not 100% brilliant - maybe a 1-2mm gap but it was thouroughly sealed with colorfill up to the top of the joint - I've seen a lot worse!
Thanks
I should say that this is a very small area - a coupleof centimetres long and only raised by approx 2mm. But it is noticeable. I have cleared out the old colorseal and reapplied over this area, but I still get the impression it is lifting , though it may be my imagination.
Is there anything else I can do, or is it a case of what is done is done. Will it get any worse?
Not really sure why this has happened. The joint was not 100% brilliant - maybe a 1-2mm gap but it was thouroughly sealed with colorfill up to the top of the joint - I've seen a lot worse!
Thanks