I have added a new rad to my system and it’s in a tight spot. One of the valves is leaking basically the bit you screw into the rad i think it’s too far in and cracked. I can’t really take it off as it was a nightmare and it’s risks messing other stuff up.
The system is microbore. I’ve tried some leak paste around the value it doesn’t work. The leak is very minor a drop say every hour. I could leave it. However, I saw leak sealer you can put into systems with good reviews. My worry is with it being microbore and old it may block one of the microbore pipes? Also does it play havoc with push to fit seals and compression fittings
The system is microbore. I’ve tried some leak paste around the value it doesn’t work. The leak is very minor a drop say every hour. I could leave it. However, I saw leak sealer you can put into systems with good reviews. My worry is with it being microbore and old it may block one of the microbore pipes? Also does it play havoc with push to fit seals and compression fittings