HI,
I have a counter top basin that I am trying to reuse. The Basin does not have an overflow thus I am trying to fit an unslotted free flow waste. The problem that I have is that the recess in the sink for the waste is too deep for the waste fitting as when I fit the waste the cap does not allow water to pass as it is in the recess. I have had a look at the fitting and there does not seem to be any ability to set the height of the Cap. Does anyone know of any free flow wastes that allow adjustment of the height of the cap or have any suggestions on how I could pack the waste to lift it up by a few mm while maintaining the seal?
Hope the above makes sense. Thanks in advance.
James
I have a counter top basin that I am trying to reuse. The Basin does not have an overflow thus I am trying to fit an unslotted free flow waste. The problem that I have is that the recess in the sink for the waste is too deep for the waste fitting as when I fit the waste the cap does not allow water to pass as it is in the recess. I have had a look at the fitting and there does not seem to be any ability to set the height of the Cap. Does anyone know of any free flow wastes that allow adjustment of the height of the cap or have any suggestions on how I could pack the waste to lift it up by a few mm while maintaining the seal?
Hope the above makes sense. Thanks in advance.
James