Hi,
I have got an unvented Cylinder, so get good water pressure and am about to replace a 25 year old Mira shower and tray.
I know i need to raise the shower tray to ensure I can get access to the shower trap by about 100mm, but wanted to fit a low profile tray so there isn't a massive step up into the shower when the tray is raised and fitted.
I hope to fit a 45mm profile tray, with the larger 90mm waste and then a frameless pivot door, my concern is though how do I know if the tray will overspill, due to the throughput of the shower exceeding the amount of waste water that can be carried away?? or is there little to be concerned about??
Are there any recommendations of the best trays to get, it needs to be 1000x800mm.
I am new to the forum, so sorry if this is the wrong place or a stupid question, it all seemed pretty simple when I first looked at it, but after investigation I have a lot of un-answered questions!!!
Many Thanks
I have got an unvented Cylinder, so get good water pressure and am about to replace a 25 year old Mira shower and tray.
I know i need to raise the shower tray to ensure I can get access to the shower trap by about 100mm, but wanted to fit a low profile tray so there isn't a massive step up into the shower when the tray is raised and fitted.
I hope to fit a 45mm profile tray, with the larger 90mm waste and then a frameless pivot door, my concern is though how do I know if the tray will overspill, due to the throughput of the shower exceeding the amount of waste water that can be carried away?? or is there little to be concerned about??
Are there any recommendations of the best trays to get, it needs to be 1000x800mm.
I am new to the forum, so sorry if this is the wrong place or a stupid question, it all seemed pretty simple when I first looked at it, but after investigation I have a lot of un-answered questions!!!
Many Thanks