Hi,
I have just taken over an office that has a Menvier TS690 alarm system installed. The previous tenant left no detailed info on this system, however searching the web I found how to do a factory reset and input the engineers passcode and setup a new passcode. This worked all well and good, however I now get a message saying AUX/BELL TAMPER
I am not sure what is causing this and how to clear it, I have had the internal sounder disconnected, but it is now connected back up again, do I have to "clear" this fault?
Any help would be much appreciated.
Thanks
Pete
I have just taken over an office that has a Menvier TS690 alarm system installed. The previous tenant left no detailed info on this system, however searching the web I found how to do a factory reset and input the engineers passcode and setup a new passcode. This worked all well and good, however I now get a message saying AUX/BELL TAMPER
I am not sure what is causing this and how to clear it, I have had the internal sounder disconnected, but it is now connected back up again, do I have to "clear" this fault?
Any help would be much appreciated.
Thanks
Pete