Hi Guys,
First of all thanks to everyone who contributes to this forum! Great advice, and saved a fortune.
I had the 'flashing rinse/no spin' problem and found all of the answers here.
Very simple soldering job (RS Components £5, and that included spare relay and 10 resistors!)
Two new dampers (genuine parts £75)
All up and working again.
Slight issue on the motor brushes which I was going to replace at the same time. The brushes I bought have a simple straight spade connection on them. However the current installed brushes have a strange hollow square like connection - not the same as all of the pictures I have seen.
Its a 2000 model (yes 17 years of constant use - go Miele!)
Anyone seen problems on the spade connections on the motor brush replacements?
Thanks
First of all thanks to everyone who contributes to this forum! Great advice, and saved a fortune.
I had the 'flashing rinse/no spin' problem and found all of the answers here.
Very simple soldering job (RS Components £5, and that included spare relay and 10 resistors!)
Two new dampers (genuine parts £75)
All up and working again.
Slight issue on the motor brushes which I was going to replace at the same time. The brushes I bought have a simple straight spade connection on them. However the current installed brushes have a strange hollow square like connection - not the same as all of the pictures I have seen.
Its a 2000 model (yes 17 years of constant use - go Miele!)
Anyone seen problems on the spade connections on the motor brush replacements?
Thanks