I am building a breakfast bar and would like the oak worktop to wrap around the units forming both the worktop and the end panel.
I have a 3000mm worktop and need to cut 1500mm for the top of the breakfast bar and another 900mm piece to use as an end panel. Where the 2 pieces meet on the corner I would like to mitre the joint rather than have a butt joint as I think this would look a lot nicer.
What I need to know is how to make the 45 degree cut in the worktop that forms the joint and the best way of joining the 2 pieces.
Any help would be greatly appreciated.
I have a 3000mm worktop and need to cut 1500mm for the top of the breakfast bar and another 900mm piece to use as an end panel. Where the 2 pieces meet on the corner I would like to mitre the joint rather than have a butt joint as I think this would look a lot nicer.
What I need to know is how to make the 45 degree cut in the worktop that forms the joint and the best way of joining the 2 pieces.
Any help would be greatly appreciated.