- Joined
- 31 May 2007
- Messages
- 369
- Reaction score
- 0
- Country
Hello everyone
Ive just installed a new rad into an existing one pipe system
I've cut into the pipe and teed up out of the floor so that a single pipe is above ground. I then teed off of this above ground pipe and connected up the return to it. The tee has been made 10cm below the rad valve.
Is this ok? Will my rad heat up properly? I was worried i should have teed the two pipes from below ground. But access was an issue.
Cheers[/b]
Ive just installed a new rad into an existing one pipe system
I've cut into the pipe and teed up out of the floor so that a single pipe is above ground. I then teed off of this above ground pipe and connected up the return to it. The tee has been made 10cm below the rad valve.
Is this ok? Will my rad heat up properly? I was worried i should have teed the two pipes from below ground. But access was an issue.
Cheers[/b]