Hi there.
Looking for some advice for a newbie.
When we moved into our house nine years ago, we had to install a TV Ariel.
This was done and a further white box was added to our main TV which the Ariel went in, and the TV connection came out.
The layout of the house is simple: one TV socket on each floor, over three floors. Main TV socket is on the first floor where the White box is located.
So, over the years the connection for the White box is temperamental, meaning no signal on the tele (it also means no tele on either of the other two floors).
I've put this down to the connector going in to the wall, which with a wiggle, turned te White box light from red to green. All the worked.
Anyway, had a problem again last weekend which resulted in me taking the socket plate (?) off the wall to have a look at the connection which seemed ok.
When puting this back on it wouldn't sit slush to the wall, but still managed to wiggle and get a connection.
So this weekend I have put on a new socket plate and put a new end on the cable.
Turned the White box on and bingo...green light all the time even with moving the wire.
Turned the tele on, no signal. Retuned, nothing. Changed to the old connector, nothing.
Completely lost as this should have worked!
Does anybody had any ideas or suggestions before I make that call?
TIA.
Chris
Looking for some advice for a newbie.
When we moved into our house nine years ago, we had to install a TV Ariel.
This was done and a further white box was added to our main TV which the Ariel went in, and the TV connection came out.
The layout of the house is simple: one TV socket on each floor, over three floors. Main TV socket is on the first floor where the White box is located.
So, over the years the connection for the White box is temperamental, meaning no signal on the tele (it also means no tele on either of the other two floors).
I've put this down to the connector going in to the wall, which with a wiggle, turned te White box light from red to green. All the worked.
Anyway, had a problem again last weekend which resulted in me taking the socket plate (?) off the wall to have a look at the connection which seemed ok.
When puting this back on it wouldn't sit slush to the wall, but still managed to wiggle and get a connection.
So this weekend I have put on a new socket plate and put a new end on the cable.
Turned the White box on and bingo...green light all the time even with moving the wire.
Turned the tele on, no signal. Retuned, nothing. Changed to the old connector, nothing.
Completely lost as this should have worked!
Does anybody had any ideas or suggestions before I make that call?
TIA.
Chris