Hi some help would be really appreciated. I have just replaced a shower and pump the previous set up was a mixer using a single impleller pump I have replaced it with a thermostatic mixer and twin impeller pump (2 bar Salamander). The pump is directly above the shower.
When the pipe work was first put in place we flushed through (with pump switched off and got water from both the hot and cold feeds) we then connected the shower and again after a spluttery start got flow from the head (a large rose) and the hand attachement) (lots of flow when pump on!). We then switched off and moved on to another problem with the bath plumbing having to drain the system again.
Now the bath is solved and we refill the system and we come to use the shower we are getting no water from it at all. Help what to do.
Bit of site background it is a three floor house, the shower and hot water tank are on the middle floor and the cold water tank is on the floor above (top floor). all pipe work to the pump and to the shower mixer is 22mm. The house is quite a large vistorian property so very long and quite thin so the hot water tank is about 35 ft from the shower
When the pipe work was first put in place we flushed through (with pump switched off and got water from both the hot and cold feeds) we then connected the shower and again after a spluttery start got flow from the head (a large rose) and the hand attachement) (lots of flow when pump on!). We then switched off and moved on to another problem with the bath plumbing having to drain the system again.
Now the bath is solved and we refill the system and we come to use the shower we are getting no water from it at all. Help what to do.
Bit of site background it is a three floor house, the shower and hot water tank are on the middle floor and the cold water tank is on the floor above (top floor). all pipe work to the pump and to the shower mixer is 22mm. The house is quite a large vistorian property so very long and quite thin so the hot water tank is about 35 ft from the shower