Dear All
First post so apologies if this has already been answered or I've raised it in the wrong place.
I've just replaced my ensuite extractor fan and ducting - run is 5 mtrs - due to the previous vent hose being full of water! I've fitted a Manrose CF100T due to it's ability to move the air over the 5 mtrs, which I assume the previous one couldn't. It had also only been vented in to the soffit area, so I've fitted a standard grille vent to the soffit and connected the new ducting to it. All good to start with.
However, I've now found the the inbuilt backdraught shutter in the fan clatters about in the wind, which comes flying up the nice new non watery ducting. Can anyone suggest a way of making the shutters fit more tightly, so as they dont move about so much?
Thanks
John
First post so apologies if this has already been answered or I've raised it in the wrong place.
I've just replaced my ensuite extractor fan and ducting - run is 5 mtrs - due to the previous vent hose being full of water! I've fitted a Manrose CF100T due to it's ability to move the air over the 5 mtrs, which I assume the previous one couldn't. It had also only been vented in to the soffit area, so I've fitted a standard grille vent to the soffit and connected the new ducting to it. All good to start with.
However, I've now found the the inbuilt backdraught shutter in the fan clatters about in the wind, which comes flying up the nice new non watery ducting. Can anyone suggest a way of making the shutters fit more tightly, so as they dont move about so much?
Thanks
John