optima compact g3 keypad make siren noise

[hasso]

hello i put my alarm on from the mains and pressed everything and then i found out the noise was comming from the keypad i pressed everything and then the noise was still comming then i looked outside the bell box was flashing. wot shall i do as i have got tenants moving in september by the way its a OPTIMA COMPACT G3 control panel.

 

[JohnD]

I'm pretty sure it's time you called in an experienced alarm engineer.

see also
//www.diynot.com/forums/viewtopic.php?p=638729#638729
//www.diynot.com/forums/viewtopic.php?p=634590#634590

 

[hasso]

no it aint time i called a experienced engineer because it aint the same house its a different house

 

[breezer]

putting in the right code would help.

I am guessing that as you said you turned it on from the mains, it has been off for some time, when it was on some one may have changed the code, so putting in the wrong code will not stop it

 

[hasso]

im not sure i know the code

 

[breezer]

i figured that.

you either need to default it, get the right code or call an alarm co who deal with these panels

 

[hasso]

default it ??

 

[breezer]

yes, deafault it.

you default the panel back to its origonal status /settings, which will include all codes.

I dont have a manual for one of them

 

[hasso]

how shall i do that

 

[breezer]

how shall i do that

................I dont have a manual for one of them

 

[securespark]

I have a G3 manual. Is it on contract?

 

[hasso]

nope

 

[securespark]

I guess you've tried the factory set codes?

Try powering down. Upon powering up, enter program mode using the engineer code, then press reset x 2 within 5s. This will reset the panel to default conditions.

My manual does not mention how to reset the NVM otherwise.