Optima G3 - Alarm Won't Stop After Power Cut

[spj555]

Evening All,

I'm new to the forum having just found it trying to sort my problem, so hope someone on here can help out.

Optima G3 Compact alarm.
I had a new Electricity meter just fitted. When The engineer restored the power, the alarm went off and will not stop

I have entered my code which did nothing though I still think the system recognises it as I entered the number to set and un-set the alarm and the panel responded but the outside bell did not.

Any ideas as to what the issue may be and how to rectify it?

many thanks

 

[sparkymarka]

Try 0123 factory code if this works it's defaulted back to factory set

 

[spj555]

Try 0123 factory code if this works it's defaulted back to factory set

Thanks I'l give that a try and see what happens.

cheers

 

[Europlex]

Well, did that do it?

 

[spj555]

Well, did that do it?

it was too late yesterday. Will be a job for more civilised hours later on. I'll post the result.

 

[spj555]

Well, did that do it?

Unfortunately not. Again, panel responds to my code but Bell continues ringing.

Any other suggestions would be appreciated.

Cheers

 

[sparkymarka]

Power up again enter your code AND press reset does this stop the bell ? Only other thing you can do is remove bell - wire B and see if it stops...