I have just completed the felt and battoning on my garage roof and have ordered all my tiles etc to start tiling, ive done a few small roofs before but never one with a hip running down each corner. The tiles im using are the redland plain type about 10.5 inches by 6.5 inches.
Ive just layed a couple of samples up there and i know that im going to have to cut the end ones at an angle so they run up the hip, but this provides a problem. When cutting the tile at an angle I lose one of the nibs that the tile hangs on and this make them want to slide down on one side
I have ordered some tile and a halves too, but do i need to use 1 of these on both ends of every row or is there another way to secure them.
Many Thanks Guys.
Ive just layed a couple of samples up there and i know that im going to have to cut the end ones at an angle so they run up the hip, but this provides a problem. When cutting the tile at an angle I lose one of the nibs that the tile hangs on and this make them want to slide down on one side
I have ordered some tile and a halves too, but do i need to use 1 of these on both ends of every row or is there another way to secure them.
Many Thanks Guys.