I am after a bit of advice, I have a porch which Is built out of 9” brick wall with no cavity.
I have studded the walls on the inside and filled with 90mm Celotex. There is a UPVC door that leads to the outside (will be changed) and a Timber door that will lead into the hallway. All the ground floor of the house has wet under floor heating, and will be tiled with porcelain tiles.
My problem is the porch floor is some 60mm lower than the hallway and I would like to raise this to the same level as the hall and carry the tiles all the way though.
The existing floor in the porch is quarry tiles that are in sound crack free condition but doubt there is a DPM present.
I would like to install DPM into the floor and if possible insulation, but not sure how to go about doing this??
Can anyone advise what would be best.
Thanks
I have studded the walls on the inside and filled with 90mm Celotex. There is a UPVC door that leads to the outside (will be changed) and a Timber door that will lead into the hallway. All the ground floor of the house has wet under floor heating, and will be tiled with porcelain tiles.
My problem is the porch floor is some 60mm lower than the hallway and I would like to raise this to the same level as the hall and carry the tiles all the way though.
The existing floor in the porch is quarry tiles that are in sound crack free condition but doubt there is a DPM present.
I would like to install DPM into the floor and if possible insulation, but not sure how to go about doing this??
Can anyone advise what would be best.
Thanks