Blimey..whats going on here!!!
I changed the whole PRV as it is a push fit type. It is acting exactly the same as the one I changed so seems a bit coincidental but the fact both may be faulty did cross my mind.
The gauge I go by is the one on the boiler of which the red needle is just after 1.2bar
I think I found the expansion vessel today located at the rear of the boiler. I noticed a red cylinder with a pipe coming out of the bottom which lead to the PRV area and the drain plug..is this it??
However, the pipe and nut leading from the vessel was green from water corrosion by the looks of it??
I would post a picture but there is no way I'd be able to get that near...It is a Ravenheat after all
I changed the whole PRV as it is a push fit type. It is acting exactly the same as the one I changed so seems a bit coincidental but the fact both may be faulty did cross my mind.
The gauge I go by is the one on the boiler of which the red needle is just after 1.2bar
I think I found the expansion vessel today located at the rear of the boiler. I noticed a red cylinder with a pipe coming out of the bottom which lead to the PRV area and the drain plug..is this it??
However, the pipe and nut leading from the vessel was green from water corrosion by the looks of it??
I would post a picture but there is no way I'd be able to get that near...It is a Ravenheat after all