I will run several wet UFH circuits (ground floor to be screeded system and 1st and 2nd floor pro-fix panels and then to be screeded / levelling compound).
Is it best to pressure test these? If so, what pressure does UFH normally operate at, is it between 1 and 2 bars like a boiler?
The above questions are just for my own interest, builders will be doing the work.
Is it best to pressure test these? If so, what pressure does UFH normally operate at, is it between 1 and 2 bars like a boiler?
The above questions are just for my own interest, builders will be doing the work.