Hello to all of u again!
Hmmm, ive still got problems with this primatic, one pipe system...any of u SuperPlumbers got any ideas?
I drained the system and refilled it. Everything is going well except for the rad in the bathroom. When the heating is on, the pipes to the bathroom rad are cold and sometimes a little bit warm and its impossible to bleed the rad (seems like there is no water going to the rad to fill it) BUT when the heating is turned off, the pipe to the rad gets warm and loads of air can be bled from the rad until its full of water and it warms up a little bit. Then when the heating is turned on again the pipe to the rad gets cold and again it seems that the rad cannot be bled?!? I had better mention again that the heating system is a one-pipe type.
Any of u guys got any ideas or explanations...im stumped!
Thanks...Jimbobplumb
Hope everyones not too busy...if it snows, take a day off and get the sleigh out of the shed!
Hmmm, ive still got problems with this primatic, one pipe system...any of u SuperPlumbers got any ideas?
I drained the system and refilled it. Everything is going well except for the rad in the bathroom. When the heating is on, the pipes to the bathroom rad are cold and sometimes a little bit warm and its impossible to bleed the rad (seems like there is no water going to the rad to fill it) BUT when the heating is turned off, the pipe to the rad gets warm and loads of air can be bled from the rad until its full of water and it warms up a little bit. Then when the heating is turned on again the pipe to the rad gets cold and again it seems that the rad cannot be bled?!? I had better mention again that the heating system is a one-pipe type.
Any of u guys got any ideas or explanations...im stumped!
Thanks...Jimbobplumb
Hope everyones not too busy...if it snows, take a day off and get the sleigh out of the shed!