K
kai
I have seen a lot of comments about pulling the main supply fuse, i.e. the one with 100amps printed on it, in the big black box that comes at the end of the incoming service cable, in order to replace the old fusebox etc.
What is the current position, as I always though it was ILLEGAL to tamper with the Boards Seals and Equipment?
I would call the Board in to test and connect my new Consumer Unit to the mains, and disconnect the old fusebox at the same time.
What is the current position, as I always though it was ILLEGAL to tamper with the Boards Seals and Equipment?
I would call the Board in to test and connect my new Consumer Unit to the mains, and disconnect the old fusebox at the same time.