Pyronix Deltabell Sounding when go into master engineer code

[rob waterston]

Hi

I have set up my new alarm system Pyronix Euro 46 Version 10 on the bench before install and on fitting a Deltabell X with Lightbox
setup as Photos attached it rings the bell sounder on entering Programing eg 1111, I have also programmed the hold off to 0059 and connected to
NO and linked 0v to C.

Any Help would be great

 

[sparkymarka]

Remove the bell trip ( blue wire ) at the bellbox …..does it still do it ?

 

[rob waterston]

No it does not I not sure what else i have done but got SAB tamper now also

 

[rob waterston]

sorted tamper switch on box not flat so was not off

 

[sparkymarka]

Have you programmed the correct output ?

 

[rob waterston]

Change outputs
Endstation outputs
Bell O/P 0059 Engineer Access

Shoul I be Able to meter open and closed on the N/O contact after the 1111 Code is input

 

[sparkymarka]

You have changed the bell output ….that why it’s ringing …you need to set the relay to engineer access and change the bell output back …

 

[rob waterston]

Put bell output back to 0014

Where do i set eng relay

 

[sparkymarka]

What does it say at side of relay ? PG1 ?

 

[rob waterston]

PGM O/P 1= Fire

 

[rob waterston]

PGM O/P {0001}
Fire

 

[sparkymarka]

Change it to 059

 

[rob waterston]

Sorted Very Helpfull Thanks

Now i can move on to my last item Twin Alert Hope I can do better on that