I am going to be fitting a new vented hot water cylinder.
Someone told me not to use ptfe tape on the connections.
I can see that I wont need to use it on the immersion heaters as these have a washer.
What about on the other connections though (1 inch-22mm male connections)
I would have thought I would have needed tape on these.
Please can someone advise what is the correct way to connect these male connectors.
Cheers Jim
Someone told me not to use ptfe tape on the connections.
I can see that I wont need to use it on the immersion heaters as these have a washer.
What about on the other connections though (1 inch-22mm male connections)
I would have thought I would have needed tape on these.
Please can someone advise what is the correct way to connect these male connectors.
Cheers Jim