Hello all,
a seemingly simple question, to which I have struggled to find a simple answer.
Is it good practice to cut a radiator tail to correct length?
If it is acceptable, is it a hacksaw-and-deburr job? I guess a pipe cutter might struggle, as tails are harder than copper......
I don't fancy altering pipework, to accommodate the new rads.
TIA
Finally,
jointing compound on the tail thread?
PTFE on the tail olive?
a seemingly simple question, to which I have struggled to find a simple answer.
Is it good practice to cut a radiator tail to correct length?
If it is acceptable, is it a hacksaw-and-deburr job? I guess a pipe cutter might struggle, as tails are harder than copper......
I don't fancy altering pipework, to accommodate the new rads.
TIA
Finally,
jointing compound on the tail thread?
PTFE on the tail olive?