Right I'm modernising my Kitchen, I have an old grey boiler programmer that I'd like to swap to my new programmer.
My old Programmer is a Potterton EP2002
My new Programmer is a Honeywell ST9400C
I read on a forum that it is possible to change over, however I didn't realise so many wires were involved! So here are some pictures:
Old Back Plate:
Old Programmer - rear of:
New Programmer - Rear of:
Wires:
Anyone any ideas? I'd appreciate any information!
Thanks in advance!
My old Programmer is a Potterton EP2002
My new Programmer is a Honeywell ST9400C
I read on a forum that it is possible to change over, however I didn't realise so many wires were involved! So here are some pictures:
Old Back Plate:
Old Programmer - rear of:
New Programmer - Rear of:
Wires:
Anyone any ideas? I'd appreciate any information!
Thanks in advance!