In order to replace a syphon diaphragm, on a toilet where the cistern 'sits' directly on the toilet basin rather than by plastic pipe, I've had to completely remove the cistern, which has involved disconnecting overflow and water supply too.
I cannot get a watertight seal again between the water supply (copper) and inlet valve (plastic). The washer in the metal connection is in place.
What am I doing wrong?
THanks in advance for any replies to this noob.
I cannot get a watertight seal again between the water supply (copper) and inlet valve (plastic). The washer in the metal connection is in place.
What am I doing wrong?
THanks in advance for any replies to this noob.