- Joined
- 22 Sep 2015
- Messages
- 21
- Reaction score
- 0
- Country
I replaced a sensor using the configuration in the attached photo. It matches that of another sensor in the house. However I keep getting a tamper light.
Does it need an engineers reset after a sensor change or does this indicate bad wiring?
Also I noticed from online tutorials the normal colours for tamper are green and yellow but someone had wired them as green and white on one sensor. Has this happened to work because of they way they connected it at the panel? I'm guessing best practice is green and yellow make up the tamper?
Does it need an engineers reset after a sensor change or does this indicate bad wiring?
Also I noticed from online tutorials the normal colours for tamper are green and yellow but someone had wired them as green and white on one sensor. Has this happened to work because of they way they connected it at the panel? I'm guessing best practice is green and yellow make up the tamper?