In the next couple of weeks I will be replacing the existing Bath/Shwer Mixer Tap. Have spent a bit of time looking at the fitting of the existing mixer. A couple of questions I need answers to.
1. The existing connections show 22mm supply pipe to the hote water tap, but 15mm to the cold tap, is this normal?, I have looked at Screwfix item no, 13393 a Swirl Bath Mixer, it makes no comment on the connections.
2. The current connections are direct from the supply pipes to the tails of the hot and cold tap, I intend to change this connection to a flexible SS connection with a valve built in, using push fit, just a silly point, does the push fit end of the flexible pipe go direct onto the supply pipe and the washer screw end onto the tails.
Any advice much appreciated.
1. The existing connections show 22mm supply pipe to the hote water tap, but 15mm to the cold tap, is this normal?, I have looked at Screwfix item no, 13393 a Swirl Bath Mixer, it makes no comment on the connections.
2. The current connections are direct from the supply pipes to the tails of the hot and cold tap, I intend to change this connection to a flexible SS connection with a valve built in, using push fit, just a silly point, does the push fit end of the flexible pipe go direct onto the supply pipe and the washer screw end onto the tails.
Any advice much appreciated.