Hi,i have a glowworm flexicom 24cx.I have just replaced a faulty water pump(seized) and dec ided to test the system with the gas still turned off.I t went through its usual start up procedure and then F1 came up which was expected as there was no gas.The problem is i cant get rid of this fault code display.Is there a reset procedure i can use.Thanks for any help.
reset fault condition
- Thread starter ifearnobeer
- Start date
Sponsored Links
The reset button is under the digital display window.
Thanks 45xxx how didn't i notice that.I'll strip down the old pump now and see if i can free it.I may need it again.Is a seized pump a common fault with boilers?
Sponsored Links
I wish I had a fiver for every pump I've replaced. 
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
