- Joined
- 30 Dec 2015
- Messages
- 12
- Reaction score
- 0
- Country
Hi, after a bit of advice, over the last month I've installed a Texecom premier elite 24 (after taking lots of info from this forum!).
I though I had everything set up but I did the walk test on Saturday and I couldn't get any of the LEDs on the PIRs to activate or the panel to chime (all of the zones did register on the panel though). I did a bit of investigation and noticed that in the zone options I still have the wiring options. according to the manual the wiring options should be replaced by ricochet device options once learnt?
I did some part arm tests and couldn't get the alarm to activate when I wandered into the rooms
if I monitor the system on the ricochet software each PIR does register some movement initially but won't register any future movement in that zone
Any advice would be gratefully received, I don't think I can handle reading the manual again
Here's a few screen shots of the set up
I though I had everything set up but I did the walk test on Saturday and I couldn't get any of the LEDs on the PIRs to activate or the panel to chime (all of the zones did register on the panel though). I did a bit of investigation and noticed that in the zone options I still have the wiring options. according to the manual the wiring options should be replaced by ricochet device options once learnt?
I did some part arm tests and couldn't get the alarm to activate when I wandered into the rooms
if I monitor the system on the ricochet software each PIR does register some movement initially but won't register any future movement in that zone
Any advice would be gratefully received, I don't think I can handle reading the manual again
Here's a few screen shots of the set up