Hi lads /lasses,
Hope this is in the correct forum?
I've a motorised single roller garage door that won't open fully or closes too much (motor keeps running even after it's physically closed)
To cut a long story short, I closed the door today with remote (with my back turned) then only to hear a massive clattering sound..... as I turned round I a saw a broom I had forgot was propped against the wall had fell and jammed the door about halfway through its travel, preventing it from closing fully but the motor was still running. Not good.
Looks like it's been knocked out of sync
There is a control box on the wall in the garage and I've took off the cover - it has 2 little white dials and a little button. I'm surprising these are limit stops of some sort - which determine the amount of travel etc?
Anyone provide any advice before I start twiddling?
Thanks in advance
Hope this is in the correct forum?
I've a motorised single roller garage door that won't open fully or closes too much (motor keeps running even after it's physically closed)
To cut a long story short, I closed the door today with remote (with my back turned) then only to hear a massive clattering sound..... as I turned round I a saw a broom I had forgot was propped against the wall had fell and jammed the door about halfway through its travel, preventing it from closing fully but the motor was still running. Not good.
Looks like it's been knocked out of sync
There is a control box on the wall in the garage and I've took off the cover - it has 2 little white dials and a little button. I'm surprising these are limit stops of some sort - which determine the amount of travel etc?
Anyone provide any advice before I start twiddling?
Thanks in advance