Hi all, need a it of advice. Trying to fit a new power socket in the living room but trying to spur off the original socket in the corner. The wall is dot & dab, but the original socket is totally surrounded by adhesive, is it possible to drill a channel in the adhesive and run the cable through this and clip it too the block?
Running cable in dot & dab wall
- Thread starter BThomas
- Start date
Sponsored Links
Nothing wrong with running the cable in that way, but you need to be sure the socket you are spurring off is not already a spur from a ring. You also need to keep your cable route within the safe zone created by your existing and new socket.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
