I have a Salamander Force 15TU pump which feeds hot and cold water to the Wash Basin and Shower in the batrhroom (only).
The pump intermittently refuses to start. If you leave the tap running and go quickly to the hotwater cylinder cupboard where the pump is located and switch the electical socket outlet on and off in relatively quick succession there is the noise of the motor trying to start but no rotation. Eventually the motor starts up. (sometimes 1 or 2 clicks, sometimes (say) a full minute of clicks.) and runs quite happily. No loss of pressure, no strange noises.
If you're not quick enough to switch the supply off you can here the motor trying to start and there is a distinct brief smell of electrical overheating and nothing happens for a short while. Then we go through the above proceedure and it'll start. (I assume there is a safety cut-out operating when this happens)
Once it's started sometimes it won't start the next time we turn on the taps and sometimes it does. We have had a period of around 3 weeks with it starting ok, and then we may get a short period of say 4 attempts when it won't start.
For info, we have mixer taps both for the shower and the wash-basin. And this has been going on for around 3 months.
Any suggestions? We have had the plumber who installed it to look at it and he's stumped.
Thanks
Mike.
The pump intermittently refuses to start. If you leave the tap running and go quickly to the hotwater cylinder cupboard where the pump is located and switch the electical socket outlet on and off in relatively quick succession there is the noise of the motor trying to start but no rotation. Eventually the motor starts up. (sometimes 1 or 2 clicks, sometimes (say) a full minute of clicks.) and runs quite happily. No loss of pressure, no strange noises.
If you're not quick enough to switch the supply off you can here the motor trying to start and there is a distinct brief smell of electrical overheating and nothing happens for a short while. Then we go through the above proceedure and it'll start. (I assume there is a safety cut-out operating when this happens)
Once it's started sometimes it won't start the next time we turn on the taps and sometimes it does. We have had a period of around 3 weeks with it starting ok, and then we may get a short period of say 4 attempts when it won't start.
For info, we have mixer taps both for the shower and the wash-basin. And this has been going on for around 3 months.
Any suggestions? We have had the plumber who installed it to look at it and he's stumped.
Thanks
Mike.