Sanding Floors - How to remove Tar-like coating first?

Joined
21 Dec 2007
Messages
129
Reaction score
4
Country
United Kingdom
Sanding some old floors using a belt sander, for the most part this is doing a good job.
However, some areas of the floor are covered in a dark-coloured coating which just clogs the sanding belt up in no time. I've tried nitromors but this doesn't do anything. A heat gun and scraper helps but doesn't get rid of it all; what does come up forms a mound of 'tar' on the scraper. What could this coating be and how can I get rid of it? Presumably a drum sander would have the same problems trying to sand it.

I've attached some pics...

IMG_8879.JPG
IMG_8880.JPG
IMG_8882.JPG
 
Sponsored Links
Possibly the natural resin from the timber itself combined with dirt. Do the boards have a distinctive turpentine or pine air fresh smell about them? Either way I'd scrape the affected areas in the direction of the grain thoroughly then clean off with a Webrax (white semi-abrasive) pad soaed in white spirits. As ytou are probably now aware, any attempt to sand resinous timber simply results in the sanding material loading upand glazing or clogging in double quick time
 
Thanks, tried this but white spirit making no difference. Tried nail varnish remover and this took a little off but not much. It definitely appears that half the room has been actually treated with whatever it is, rather than resin as it's very distinct and the other half of the room is not affected.
 
In that case it may well be down to hand scraping the floor with a Bahco 665 carbide floor scraper to get the stuff off.

Bahco 665 HD Scraper 001 01.jpg


Whilst these aren't as good as the old Skarsten-type heavy duty scrapers (which disappeared about 2001/02) they allow quick hand scraping of largish areas although it is hard work
 
Sponsored Links
Can you turn the board over. The trick is to use a nail punch (or anything the size of the nail) to punch the nails through, and then lift the board out without any damage.
 
That sort of depends - in our house the boards are T&G but only planed on the top surface. They also cracked rather badly when I tried getting them out. Hope the OP has better luck tha I did
 
sounds like the blacking they used to use around the edges. What grade abrasive are you using. Anything finer than around 40grit will clog and then just reset spread around the adjacent boards.
I would start off with 40 grit or even 24 if it's really stubborn
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top