Would like to clean up the face of my sandstone lintels. Tried with various wheels in the angle grinder (9" & 4"), but end up with a very un-even surface.
Same goes for york stone steps that are dished with a hundred years of feet. Loads of character, but would like to take down the un-worn side areas to level out with the worn bits.
Anyone got any idea how I can get flat surfaces?
Thanks in advance for any advise.
Same goes for york stone steps that are dished with a hundred years of feet. Loads of character, but would like to take down the un-worn side areas to level out with the worn bits.
Anyone got any idea how I can get flat surfaces?
Thanks in advance for any advise.
