Scantronic 9448

[yariso]

Hello,

I have just moved into a new house and it has this alarm installed. It has 4 zones, 3 downstairs and 1 upstairs. I want to part set it to turn the landing zone off at night. The instructions say:

TO PART SET Your alarm system may have been installed to allow you to have part of the premises set while other area(s) are off. To part set the system key in 2 then ENTER, followed by your user code. Note that the part set exit tone is usually a buzzer sound, but your system may be programmed to silent set.

However, this doesn't tell me how to pick the zones.

Can anyone help?

 

[Europlex]

...................................
TO PART SET Your alarm system may have been installed to allow you to have part of the premises set while other area(s) are off. To part set the system key in 2 then ENTER, followed by your user code. Note that the part set exit tone is usually a buzzer sound, but your system may be programmed to silent set.
...........

Have you set it as above to give it a go? I suspect the ZONE, LANDING has already been programmed.
Turn it on, go upstairs into bedroom, when alarm has full set walk out onto the landing, then you will have your answer.

 

[yariso]

Yeah i have done that. I part set it, went upstairs and the PIR detected me

 

[Handymanjo]

What light lit up on the control panel when you triggered the landing?

 

[yariso]

The landing zone number

 

[Handymanjo]

What number is that ? 1,2,3
If number 2 then to part set = 2 enter then code number this will turn of zone 2 in part set
If number 3 then to part set = 3 enter then code number this will turn off zone 3 in part set
The zone light will light up when alarm triggered that will tell you what is on that zone

 

[yariso]

You are a star Many thanks