Hi i have a scantronic 9488 - 3 zone model alarm
i have just had to re-wire the whole electricity in the house and had to reset the alarm.
So, i have used the manual and reset the alarm code etc - all fine.
However, only 2 zones are active, zone 3 is not wired into anything. the alarm does not set because of this (i think) - each time i set it, it goes off after 10 secs or so. I've tried to follow the manual to reset the "zone programming" using command "15", however the alarm doesnt recognise this and keeps throwing back a incorrect bleep. Is there another command that i should be using to de-activate zone 3?
Any help would be great - splitting my hair here!!
i have just had to re-wire the whole electricity in the house and had to reset the alarm.
So, i have used the manual and reset the alarm code etc - all fine.
However, only 2 zones are active, zone 3 is not wired into anything. the alarm does not set because of this (i think) - each time i set it, it goes off after 10 secs or so. I've tried to follow the manual to reset the "zone programming" using command "15", however the alarm doesnt recognise this and keeps throwing back a incorrect bleep. Is there another command that i should be using to de-activate zone 3?
Any help would be great - splitting my hair here!!