Scantronic 9651EN-00 Bell Unit output SAB or SCB?

[Zorro6]

Hi. Does anybody know what the bell/strobe output is on this unit. I am changing a Scantronic 9200 control panel and don't want to have to buy a new bell unit.
A link to a installation wiring diagram would be good! Thanks

 

[Atilla]

yes don`t panic - its the universal config.


output 1 - bell

output 2 - strobe

output 3 - spare




and you can switch them, your old system was just wired with the strobe switched positive because it was done wrongly.

 

[Zorro6]

That sounds good. I had visions of my strobe not working. All the systems seem to have a switched negative output for the strobe except my old Scantronic 9200. Does it really matter for a strobe anyway?

 

[Atilla]

That sounds good. I had visions of my strobe not working. All the systems seem to have a switched negative output for the strobe except my old Scantronic 9200. Does it really matter for a strobe anyway?

it goes back to when a strobe really was a strobe - needed a relay (like in the 9200) to actually turn the thing off - not that little light you get now.