As can be seen from previous posts I am currently attempting to re establish an inherited Scantronic 9800 alarm system, decommissioned some years ago. I am slowly getting my head around the operations of the Keypad (Series 3200)
What I am now trying to get straight in my head is the zoning.
I have what I believe to be quite a simple arrangement.
Cct1 = PIR Hallway (If I remember back far enough I think a door contact was also in circuit with the PIr but I may be wrong?)
Cct2 = PIR Living Room
Cct3 = Door contact Garage
Cct3 = Panic Alarm in Bedroom
I have now managed to enter engineering mode (E) and I think I have seen the configuration settings for the four circuits. after entering E mode I typed:
01 which displayed (scrolling) FE (Final Exit) followed by b (armed in part set B ) followed by 1 (i think is cct number?)
02 which displayed Al (Normal Alarm) followed by b followed by 2
03 which displayed Al (Normal Alarm) followed by b followed by 3
04 which displayed FE (Final Exit) there appeared to be no value for the "y" setting followed by 4
05 to 08 indicated nu (Not Used)
The Keypad indicates 3 zones (A,B and C) each with a led alongside it, although to date I have not seen these leds illuminate.
An idiots guide would be very much appreciated
What I am now trying to get straight in my head is the zoning.
I have what I believe to be quite a simple arrangement.
Cct1 = PIR Hallway (If I remember back far enough I think a door contact was also in circuit with the PIr but I may be wrong?)
Cct2 = PIR Living Room
Cct3 = Door contact Garage
Cct3 = Panic Alarm in Bedroom
I have now managed to enter engineering mode (E) and I think I have seen the configuration settings for the four circuits. after entering E mode I typed:
01 which displayed (scrolling) FE (Final Exit) followed by b (armed in part set B ) followed by 1 (i think is cct number?)
02 which displayed Al (Normal Alarm) followed by b followed by 2
03 which displayed Al (Normal Alarm) followed by b followed by 3
04 which displayed FE (Final Exit) there appeared to be no value for the "y" setting followed by 4
05 to 08 indicated nu (Not Used)
The Keypad indicates 3 zones (A,B and C) each with a led alongside it, although to date I have not seen these leds illuminate.
An idiots guide would be very much appreciated