Hi all,
I've just drilled a hold in the wall beside my front door and the Scantronics 9851 system is now complaining about a tamper on Z01 (though I drilled at a diagonal so I would have assumed the cables would run horizontally from the door contacts....)
Anyhow I don't have an Engineer code and unfortunately I don't know who installed the system in the first place. I just want to disable the zone with the door for now (I rarely use my alarm).
The unit comes up disable zone but then it shows 01X which I'm assuming means I can't disable the zone.
Any help would be appreciated,
Thx,
Peter
I've just drilled a hold in the wall beside my front door and the Scantronics 9851 system is now complaining about a tamper on Z01 (though I drilled at a diagonal so I would have assumed the cables would run horizontally from the door contacts....)
Anyhow I don't have an Engineer code and unfortunately I don't know who installed the system in the first place. I just want to disable the zone with the door for now (I rarely use my alarm).
The unit comes up disable zone but then it shows 01X which I'm assuming means I can't disable the zone.
Any help would be appreciated,
Thx,
Peter