I have a metal back box where one of the screws isn't gripping in the lugs for the screw.
I have tried swapping the screws but have the same issue. If I apply pressure when screwing, it goes through the lug but doesn't have any effect as the socket is still loose on this end.
I could replace the box but likely to cause collateral damage. Was wondering if there are any tips for this.
Thanks in advance.
I have tried swapping the screws but have the same issue. If I apply pressure when screwing, it goes through the lug but doesn't have any effect as the socket is still loose on this end.
I could replace the box but likely to cause collateral damage. Was wondering if there are any tips for this.
Thanks in advance.