Hi,
I am installing a shower which has 3/4" BSP female fittings for hot and cold inlets. It also comes with (optional) adapters to give me a 1/2" BSP male fittings instead.
The weight of the shower mixer is taken on the pipes and it will be mounted through a stud wall, so I need some sort of elbow, mounted on a wooden panel behind the wall.
I have 22mm hot and 15mm cold feeds. Cold feed could be converted to 22mm easily.
How do I do this? Finding the right combination of connectors seems very hard. It needs to take the weight, so there needs to be a wall elbow in there somewhere.
I can come up with a number of ways of doing it, but can't find any way where all the bits are readily available in the right sizes.
I can get bits from Screwfix and/or Wickes.
Thanks very much!
-Mark
I am installing a shower which has 3/4" BSP female fittings for hot and cold inlets. It also comes with (optional) adapters to give me a 1/2" BSP male fittings instead.
The weight of the shower mixer is taken on the pipes and it will be mounted through a stud wall, so I need some sort of elbow, mounted on a wooden panel behind the wall.
I have 22mm hot and 15mm cold feeds. Cold feed could be converted to 22mm easily.
How do I do this? Finding the right combination of connectors seems very hard. It needs to take the weight, so there needs to be a wall elbow in there somewhere.
I can come up with a number of ways of doing it, but can't find any way where all the bits are readily available in the right sizes.
I can get bits from Screwfix and/or Wickes.
Thanks very much!
-Mark