Hi
I have a mixer shower run off a gravity fed system, but the cold is run off the mains. Pressure for a hot shower is pretty dire, so I am going to install a single shower pump just for the hot water, as the cold is fine.
It's only a small house and there is only a kitchen sink and a bathroom sink as well as the shower. I was wondering rather than running new pipework to feed only the shower, I could just tee into the hot water to feed the other 2 sinks as well as the shower. The sink and shower are never used at the same time so enough water will be provided for the pump to work properly. Plus I will get better pressure through my taps too!
Just wondering if this is possible, and won't cause complications.
Thanks
James
I have a mixer shower run off a gravity fed system, but the cold is run off the mains. Pressure for a hot shower is pretty dire, so I am going to install a single shower pump just for the hot water, as the cold is fine.
It's only a small house and there is only a kitchen sink and a bathroom sink as well as the shower. I was wondering rather than running new pipework to feed only the shower, I could just tee into the hot water to feed the other 2 sinks as well as the shower. The sink and shower are never used at the same time so enough water will be provided for the pump to work properly. Plus I will get better pressure through my taps too!
Just wondering if this is possible, and won't cause complications.
Thanks
James