I fitted new taps to our bath. It was a bit tricky as the holes on the bath were square and thus the taps only just covered the hole corners.
I used metal tophat washers and then the tap backnut underneath...
One of the taps is spinning slightly, the backnut and tophat washer remain stationary and the tap thread spins within. What's the best way to stop it? I'm afraid of tightening the backnut anymore incase I damage something.
I used metal tophat washers and then the tap backnut underneath...
One of the taps is spinning slightly, the backnut and tophat washer remain stationary and the tap thread spins within. What's the best way to stop it? I'm afraid of tightening the backnut anymore incase I damage something.