Hi,
Can anyone advise on fitting a thermostatic shower head to Plastic pipework.
I have fitted one this week and I think it has been the cause of quite a major leak.
I have used plastic JG Speedfit throughout the whole job (New En Suite). My question is, where the actual head joins the pipe work, should I still use an insert ? The joint is a compression type fitting at this point.
Would this connection be better with a copper pipe ?
Please don't say
" The whole job would be better in copper !!", that is too late now !!
Can anyone advise on fitting a thermostatic shower head to Plastic pipework.
I have fitted one this week and I think it has been the cause of quite a major leak.
I have used plastic JG Speedfit throughout the whole job (New En Suite). My question is, where the actual head joins the pipe work, should I still use an insert ? The joint is a compression type fitting at this point.
Would this connection be better with a copper pipe ?
Please don't say
" The whole job would be better in copper !!", that is too late now !!