This tap has a clip which might be stamped out of brass sheet, it is square section, not round. The tap head fits over it so it has to be quite short.
As the clip slides up the spindle, the tap will not turn on.
I have tried squeezing it to a tighter fit but it just goes loose again.
I have some steel circlips but they are round section, are steel so they will go rusty and I think are too long for the head to fit back on.
What's the correct thing to do?
View media item 1306
View media item 1307
As the clip slides up the spindle, the tap will not turn on.
I have tried squeezing it to a tighter fit but it just goes loose again.
I have some steel circlips but they are round section, are steel so they will go rusty and I think are too long for the head to fit back on.
What's the correct thing to do?
View media item 1306
View media item 1307